Warps
Frame rests on warp while center pin scoops up ends for measurement
A reference frame makes it easy to scoop up the selected number of ends for measurement and keeps the unit perpendicular while it rests on the warp. K10, K30 & EX ranges are supplied with a 10 mm sensing pin. For the 200 and 500 range codes select either a 17 or 34 mm sensing pin
Kit Contents
- KXB Warp Tension Meter
- Instruction manual
- Carrying case
Features
- Width of the sensing pin 10 mm (17mm and 34 mm optionally available)
- Finger Support: We recommend mounting a finger support for higher tension ranges
- Roller shifting mechanism ensure easy acquisition of the running material
- Large reference frame (15 x 17 cm) is placed on the warp threads allowing the safest and most accurate mesaurements possible
- Designed to retain the peak value as tensions fluctuate. Manually reset by using the knob located in the center of the dial
Specifications
| Accuracy | ± 1% of full scale or
± 1 graduation mark on scale |
| Diameter of Scale | 41 mm |
| Housing Material | Die-cast aluminum |
| Temperature range | 50 - 113°F (10 - 45°C) |
| Air humidity | 85 % RH, max. |
| Housing dimensions(L x W x H) | 7.5 x 3.3 x 1.8 in(188 x 85 x 45 mm) |
| Weight, net (gross) | 1.2 lbs (3 lbs) |
Ranges
| K10 | 20-100 g | 10mm |
| K30 | 20-300 g | 10mm |
| EX | 100-1000 g | 10mm |
| 200 | 200-2000 g | 10mm |
| 500 | 500-5000 g | 10mm |
Operation
We recommend always measuring the same number of ends, such as 5 or 10 ends (repeat of pattern) or only a single end at a time. During measurement make sure that the ends are not pulled or pressed out of their alignment
Downloads
