Paint Test Equipment

Price: $ 1,295.00 to $ 1,895.00

---

Gloss Meter

---

The Paint Test Equipment Gloss Meter is essential where an aesthetic appearance of the coating finish is required and to ensure uniformity of the surface finish.

---

Available model: 20°/60°.

---

Price: $1,175.00

---

Paint Test Equipment E2001 Electrostatic Gun High Voltage Meter

---

Electrostatic Gun High Voltage Meter will measure electrostatic spray gun high voltages and discharge currents

---

Measurement accuracy ±1%.

---

Price: $ 1,925.93 up to $ 2,570.05

---

X3001 Digital Adhesion Tester (Standard) 0–20MPa (0–3000psi)

---

The Adhesion Tester is compliant to ISO 4624 and ISO 16276-1.

---

Gauge accuracy 0.05%FSD.

---

Price: $ 1,668.28 up to $ 1,797.10

---

X1004. Adhesion Tester (Right angle) 0-3500 PSI (0-25MPa)

---

The Adhesion Tester is compliant to ISO 4624 and ISO 16276-1.

---

Gauge accuracy ±1%FSD.

---

Price: $425.00

---

International Standards: ISO 2409, ISO 16276-2 and ASTM D3559

---

Paint Test Equipment Cross Hatch Cutter Kit - includes foam-filled carrying case, 3x illuminated magnifier and adhesion test tape (50mm) 

---

Allows an assessment to be made of the adhesion resistance of coatings to separation from substrate.

---

Price:$395.00

---

Bresle Test is supplied in an industrial Carrying Case with Bresle Patches (pack of 35), Horiba Conductivity Meter, Deionised Water (500ml), Syringe with Needle, 1413?S/cm Calibration Solution (14ml), Conditioning Solution (14ml) and Beaker.

---

This Chloride Test on steel or Salt Test on steel using the Bresle Patch or Bresle Sampler method will help to prevent coating failure due to salts such as chlorides and sulphates contaminating the surface prior to the coating application.

---

Price:$ 69.00

---

Latex-free and contamination-free Patches.

---

Price: $ 380.00

---

R1004. Testex Gauge.

---

Includes Testex Tape Coarse & Testex Tape X Coarse

---

Compliant to ISO 8503-5 and NACE SP0287.

---

Price: $149.00

---

R2006 Surface Roughness Comparator Grit
R2007 Surface Roughness Comparator Shot

---

Compliant to ISO 8503-1 and ISO 8503-2

---

Also known as Grit Comparator, Shot Comparator Blast-cleaned Steel Comparator and Blast Comparator.

---

Price: $ 508.25

---

H4001. Dewpoint Meter 0–100%rh/-10 to 70°C (14 to 160°F). Including Humidity Sensor & Surface Temp Probe

---

Measurement accuracy ±2%.

---

Compliant to ISO 8502-4.

---

Price: $ 251.00

---

P4001. Dust Test. Includes Dust Test Tape & Dust Test Charts (pack of 50)

---

Compliant to ISO 8502-4.

---

Price: $ 122.25

---

PS102. Potassium Ferricyanide Test Papers (pack of 100)

---

Spray a film of Deionised Water on an area of the blast-cleaned steel

---

The Test Paper is then held against the surface for approximately 10 seconds

---