Z2 Digital Force Gage

Z2 Digital Force Gauge with Output

The new Check-Line model Z2 is a high performance, digital force gauge which offers programmable high/low setpoints for go/no-go testing. ORANGE lights up for measurements less than Low setpoint, GREEN for between High and Low setpoint, and RED for over High setpoint.

Store up to 1000 values in memory, which can be transmitted using the Digimatic or serial output ports. Use the real time mode to display load transients, or the peak mode to capture the peak force achieved during a test. Selectable measuring units of lbf, kgf, or Newtons.

Connect a Z2 force gauge with an MX Series test stand and enable force controlled testing. Force control can automatically stop testing when the force value reaches the high setpoint programmed on the Z2 force gauge, or maintain the force between the Z2 High and Low setpoints. Force control is ideal for fatigue or non-destructive testing. 

 
Special Attachments

 Full SPC and graphing capabilities

 Automates your data collection

 Provides a running log of all measurements along with a chart of the data as well as statistical information

 Hand wheel design provides a high degree of precise control

 Optional digital distance meter

 Force Controlled operation with Z2 and ZP force gauges

 Jog, Single Cycle, Continuous Cycle, Force Control

 Sends data from a force or torque gauge and travel display to a PC for further analysis

All Z2 gauges are sold as complete kits that include the gauge, hard plastic carrying case, AC adapter/charger, and attachments (flat head, conical, chisel, notched, small hook, large hook, Y-fork, and extension rod). Built-in NiCad rechargeable batteries.